Roland V-1200HDR Guide

77
Other Features
MEMORY Screen
At the MEMORY screen, you can save the setting values for the V-1200HD in the V-1200HD’s internal memory and load a saved le to recall the
settings from an earlier state.
Memo
You can take V-1200HD setting values saved to MEMORY <1> through <8> and save them on a USB ash drive connected to the V-1200HD.
For information on how to save data to a USB ash drive, refer to the V-1200HD Owner’s Manual.
NOTE
The following values cannot be saved. All setting values other than the ones shown below are saved.
5 The setting values at the “REMOTE CAMERA Screen” (p. 73) and the setting values saved at MEMORY <1>–<8> of the “REMOTE CAMERA screen”
5 Settings specic to the V-1200HDR or V-1200HD RCS
5 The state of the dual-monitor menu display
5 Dual-monitor layouts saved at LAYOUT [1]–[4] (p. 80)
5 Setting values at the CONTROL SURFACE section (p. 31)
Using the MEMORY screen to save or recall settings is not possible when V-1200HD RCS has been started in the oine mode.
* The state of settings in the oine mode can be saved on the computer. For details, refer to “Saving Setting Values As a File on the
Computer” (p. 81).
1. Tap <MEMORY> at the ROOT MENU, making the MEMORY screen appear.
Saving Settings
This saves setting values to MEMORY 1 through 8.
1. Tap <STORE>.
<STORE> lights up.
2. Tap the memory number where you want to save the settings.
The settings are saved.
Recalling Settings
1. Tap <RECALL>.
<RECALL> lights up.
2. Tap the memory number whose settings you want to recall.
The settings are recalled.
LAST MEMORY Function
Tapping <LAST MEMORY> switches this to ON or OFF.
ON : The state of the settings on the V-1200HD is periodically saved in the V-1200HD’s internal memory.
At the next startup, the state when saved is automatically recalled.
OFF : When the power to the V-1200HD is turned o, at the next startup, the V-1200HD starts with its factory-default settings.
Values saved using the“MEMORY Screen” (p. 77) are not lost when the power is turned o. You can call up these setting values by performing a
RECALL operation.
AUTO FTB Function
Tapping <AUTO FTB> switches this to ON or OFF.
ON : Video sent from output connectors automatically fades to a black screen when <RECALL> is used to recall settings.
OFF : Video sent from output connectors is output unchanged when <RECALL> is used to recall settings.
Video output might experience corruption during recall of the settings.

Roland V-1200HDR Specifications

General

Brand	Roland
Model	V-1200HDR
Category	Controller
Language	English