Reference Manual
00809-0100-4360, Rev BA
August 2008
6-13
Rosemount 1151
Before Characterizing
the Transmitter
1. Be prepared to answer the following questions:
• Module type (AP, DP, HP, LT) on the transmitter S/N tag?
• Module range on the transmitter module tag?
• Pressure units on your pressure source?
• Serial number on the transmitter S/N tag?
2. Connect the pressure source.
3. Remove the terminal side cover of the Rosemount 1151 Pressure
Transmitter.
4. Connect power supply leads to the terminal block. Apply power to the
transmitter.
NOTE
Failure to use accurate equipment may result in a transmitter that cannot
meet its accuracy specification.
To Next Page
Loading...
