Reference Manual
00809-0100-4360, Rev BA
August 2008
2-5
Rosemount 1151
If practical, provide approximately 6 inches clearance so that a meter may be
installed later.
Circuit Side of
Electronics Housing
The circuit compartment should not routinely need to be opened when the unit
is in service. However, provide 6 inches clearance, if possible, to allow access
to the integral zero and span buttons or for on-site maintenance. The circuit
side of the housing is marked on the nameplate located on the side of the
transmitter.
Exterior of Electronics Housing
The Rosemount 1151 Smart Pressure Transmitter uses the same housing as
the Rosemount 1151 Analog. For this reason, integral span and zero
screws—non-functional on the Rosemount 1151 Smart Pressure
Transmitter—are located under the nameplate on the side of the transmitter.
To Next Page
Loading...
