Wireless Router RNX-N150RT User Manual
3.2.5 Configuration for Bridge with AP Mode
When you choose Bridge with AP on Operation Mode page in Figure 3-6, the following steps:
1. Click Next, and then Wireless Bridge Setting page will appear as shown in Figure 3-27. On
this page, please confirm all parameters, and then click Next.
Figure 3-27 Quick Setup – Wireless Bridge Setting
Wireless Name of Remote AP - The SSID of the AP your router is going to connect to as a
client. You can also use the search function to select the SSID to join.
MAC Address of Remote AP - The BSSID of the AP your router is going to connect to as a
client. You can also use the search function to select the BSSID to join.
Survey - Click this button, you can survey the AP which runs in the current channel.
Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the router can be used. It may be illegal to use the wireless function of
the router in a region other than one of those specified in this field. If your country or region is
not listed, please contact your local government agency for assistance.
When you select your local region from the pull-down list, click the Save button, then the
Note Dialog appears. Click OK.
Note Dialog
Note:
Limited by local law regulations, version for North America does not have region selection option.
- 24 -
To Next Page
Loading...
