EasyManuals Logo

Rotax 125 MAX evo Installation Instructions And Operation Manual

Rotax 125 MAX evo
Go to English
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Fig. 2
2.1.2. Fitting of the spark plug
See Fig. 3.
The engine will be supplied with a spark plug of the type DENSO IW 27.
Note: If the ambient air temperature is below 10°C / 50°F the use of a spark plug with a
higher heat range is recommended (DENSO IW 29 or 31)
Remove the transport plug from the spark plug tapping.
Verify electrode gap of spark plug. Adjust as required.
Note: The electrode gap of the spark plug should be 0.4 mm (0.016 in) to 0.6 mm (0.024
in) (for DENSO spark plugs) Only slight bending of the ground electrode is
permitted.
Fit supplied spark plug (pos. 9) and tighten to 27 Nm (239 lbf in)
Install the spark plug connector (pos. 10), ensure correct engagement.
Fig. 3
Seite/page 52/98
Ausgabe/Edition 11/2014

Table of Contents

Other manuals for Rotax 125 MAX evo

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotax 125 MAX evo and is the answer not in the manual?

Rotax 125 MAX evo Specifications

General IconGeneral
BrandRotax
Model125 MAX evo
CategoryEngine
LanguageEnglish

Related product manuals