Rotex Controller Series - Page 46

EbV Product documentation THETA NORM/UNIT
5-26
5.4.3.4.3 Cycle temperature
After confirming the switch-off time the relevant cycle temperature starts to flash on the display and can be
set using the rotary pushbutton. In the case of heating circuits the displayed cycle temperature always refers
to the desired room temperature, while in the case of the DHW circuit it refers to the desired water heater
normal temperature in the selected cycle.
A flashing cycle temperature is confirmed by pressing the rotary pushbutton.
At the same time the last cycle called starts to flash on the display so that it can be checked. Further cycles
can be selected directly and processed in the following order: SWITCH-ON TIME – SWITCH-OFF TIME –
CYCLE TEMPERATURE.