Section 10 Safety Data Sheets H85A Manual
www.rottlermfg.com
10-5
Revision Date: 29-Apr-2016
_____________________________________________________________________________________________
_____________________________________________________________________________________________
Acids. Strong oxidizing agents. Nitrites and nitrosating agents.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
TWA: 3 ppm
TWA: 6 mg/m
3
(vacated) TWA: 3 ppm
(vacated) TWA: 8 mg/m
3
(vacated) STEL: 6 ppm
3
TWA: 3 ppm
TWA: 8 mg/m
3
STEL: 6 ppm
STEL: 15 mg/m
3
STEL: 6 mg/m
3
inhalable fraction
TWA: 2 mg/m
3
Appropriate engineering controls
Individual protection measures, such as personal protective equipment
Wear safety glasses with side shields (or goggles). Avoid contact with eyes.
Wear protective gloves and protective clothing. Avoid contact with skin and clothing.
Selection of protective clothing depends on work conditions.
If exposure limits are exceeded or irritation is experienced, NIOSH/MSHA approved
respiratory protection should be worn. Positive
-pressure supplied air respirators may be
required for high airborne contaminant concentrations. Respiratory protection must be
provided in accordance with current local regulations.
General Hygiene Considerations
Handle in accordance with good industrial hygiene and safety practice.
9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Melting point / freezing point
Boiling point / boiling range
Flammability (solid, gas)
Flammability Limit in Air
Upper flammability limit:
20°C