Section 3 Safety H85A Manual
www.rottlermfg.com
3-4
Machine Operator
Operator of this H85A Honing machine should be a skilled machinist craftsman: that is well versed in the
caution, care, and knowledge required to safely operating a metal cutting tool.
If the operator is not a skilled machinist, the operator must pay strict attention to the operating procedure
outlined in this manual, and must get instruction from a qualied machinist in both the productive and safe
operation of this H85A Honing Machine.
Rottler H85A Honing equipment has the following areas of exposed moving parts that you must train
yourself to respect and stay away from when they are in motion:
Safety glasses are recommended while machine is running.
Work Clamping - Be sure work is clamped securely in accordance with the
instructions.
Hone Head Area - Keep hands completely away from the rotating honing head at ALL times.
Honing - Do not engage rotation power when hone is out of a cylinder.
Operator Controls - Familiarize yourself with the exact location of the e-stop
button so you can immediately react to an emergency.
To Next Page
Loading...
