Rottler H85A - Operating Instructions Overview

Section 5 Operating Instructions H85A Manual
www.rottlermfg.com
I
OPERATING INSTRUCTIONS
Contents
Honing In General ........................................................................................................5-1
Large Amount of Material Removal .................................................................................... 5-1
Common Surface Finishes
.................................................................................................. 5-1
Non-Plateau .......................................................................................................................................5-1
Plateau ...............................................................................................................................................5-2
New Method for Plateau Honing ......................................................................................... 5-3
Method 1: 2 Step Using CBN Stones ..............................................................................................5-3
OEM Blocks And Other Standard Duty Applications.....................................................................5-3
Dart Blocks And Darton Sleeves .....................................................................................................5-3
Method 2: 3 Step Using Plateau Brushes .......................................................................................5-3
OEM Blocks And Other Standard Duty Applications.....................................................................5-3
Dart Blocks And Darton Sleeves .....................................................................................................5-4
OEM Engines That Are Force Induction Race Applications Or Nitrous Powered.......................5-4
Method 1: 2 Step Using CBN Stones ..............................................................................................5-4
Dart Blocks And Darton Sleeves That Are Force Induction Race Applications Or Nitrous
Powered .............................................................................................................................................5-4
Oem Engines That Are Force Induction Race Applications Or Nitrous Powered ....................... 5-5
Method 2: 3 Step Using Plateau Brushes .......................................................................................5-5
Method 1: 2 Step Using CBN Stones ..............................................................................................5-5
Nascar/Prostock Applications .........................................................................................................5-5
Special Procedure for Subaru Blocks ................................................................................ 5-5
Single Step Honing Process
................................................................................................ 5-6
Using Vitrified Abrasives
..................................................................................................... 5-6
Using Diamond Abrasives
................................................................................................... 5-7
General ............................................................................................................................................... 5-7
Mounting Stones and Brushes on Stone Holders ............................................................. 5-7
Using CBN Abrasives
........................................................................................................... 5-8
Scratching .........................................................................................................................................5-8
Breaking In A New Set of Diamond Abrasives ...............................................................................5-8
Truing New Diamond Abrasives ......................................................................................................5-8
Dressing Diamond Abrasives ........................................................................................................5-10
Torn Metal ........................................................................................................................................5-10