Section 5 Operating Instructions H85A Manual
www.rottlermfg.com
5-17
Planning the Job
Block Specifications
• You will need to know the following information for the job you are planning:
• Finish bore size, cross hatch angle, and nish.
• Bore length.
• Center to center dimension of cylinders.
• If the job is a V type block, the pan rail to crank line center dimension, and cylinder offset between
cylinder banks.
Tooling Selection
You will need to decide what honing process will be used and if there will be a nal plateau process for
the job. Based on that decision use the following charts to select which hone head, stone holders, stones,
and if need brushes.
Now is also a good time to set your bore gauge to desired nal size.
To Next Page
Loading...
