Section 2 Installation H85A Manual
www.rottlermfg.com
2-15
Grounding
The machine requires a good earth ground. The grounding conductor from the incoming power source
must be connected to the grounding block located inside of the electrical cabinet. A ground rod installed
in addition to the electrical service grounding conductor is permitted, but must be connected directly
to the grounding block inside of the electrical cabinet. Connecting the ground rod to the machine base
is not permitted. Consult a Licensed Electrician in your area to assess the installation, and install the
appropriate ground rod if necessary. Failure to do so may lead to an installation that is unsafe and does
not meet national and local electric codes.
Transformer Connections
This machine has the following minimum transformer size requirement:
• 15 kVA
If a transformer is necessary for machine installation, please refer to the diagram below for connection
information. Transformers must be sized to meet the minimum power requirements listed above. Consult
a Licensed Electrician in your area for transformer selection and installation.
To Next Page
Loading...
