Section 3 Safety H85A Manual
www.rottlermfg.com
3-2
KEEP WORK AREA CLEAN. Clean spilled coolant from oor to avoid slipping
hazard.
KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safe distance from
work area.
WEAR THE PROPER APPAREL. DO NOT wear loose clothing, gloves, rings, bracelets, or other jewelry
which may get caught in moving parts. Non-Slip foot wear is recommended. Wear protective hair covering
to contain long hair.
ALWAYS USE SAFETY GLASSES Everyday
eye glasses only have impact resistant lenses,
they are NOT safety glasses.
DO NOT OVER-REACH. Keep proper footing and balance at all times.
USE THE RECOMMENDED ACCESSORIES. Consult the manual for recommended accessories. The
use of improper accessories may cause risk of injury.
CHECK DAMAGED PARTS. Before further use of the machine, a guard or other part that is damaged
should be checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, breakage of parts, mounting, and other conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced.
NEVER OPERATE A MACHINE WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS OR ALCOHOL.
Full mental alertness is required at all times when running a machine.
NEVER ALLOW UNSUPERVISED OR UNTRAINED PERSONNEL TO OPERATE THE MACHINE. Make
sure any instructions you give in regards to machine operation are approved, correct, safe, and clearly
understood.
IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES performing the intended operation, stop using
the machine! Then contact our service department or ask a qualied expert how the operation should be
performed.
No list of safety guidelines can be complete. Every shop environment
is different. Always consider safety rst, as it applies to your individual
working conditions. Use this and other machinery with caution and
respect. Failure to follow guidelines could result in serious personal
injury, damage to equipment or poor work results.
To Next Page
Loading...
