Section 5 Operating Instructions H85A Manual
www.rottlermfg.com
5-29
Begin be going to the Stones Load Setup section and inputting
the values that will be used for the block you are going to hone.
Touching one of the value boxes will bring up the number pad that
can be used to input the value you wish to use.
Select the hone head to be used by using the drop down menu.
Move down to the Stroke Setup section and input
the values for this section. Cylinder Length is the
measurement of the longest section of the cylinder.
The amount of OverStroke is usually dictated by the
clearance of bottom of the cylinder to the main web.
When clearance is not an issue a setting of .250-.500
(6.35-12.7mm) is a good place to start.
Move over to the Cross Hatch Calculator section and input the
values for this section. Cylinder Diameter will be the nished
size of the cylinders you are honing. Angle will be whatever
angle specied by the ring manufacturer or requested by the
customer. Roughing and Finish/Plateau RPM is generally set
in the 120-200 range. Operator preference and experience will
by the nal determining factor. You can touch the Calc buttons
to see what the stroke speed in IPM will be with the setting
you have entered. Change the RPM setting if you think the
IPM reading is either too high or too low.
To Next Page
Loading...
