Configuring Ethernet Ports
Configuring Wireless # (WLAN Number) Settings
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 105
Configuring Ethernet Ports
The Ethernet Ports configuration page allows you to define how the AP’s Ethernet
ports behave. You can disable ports entirely, define trunking and packet forwarding
behavior, configure 802.1X authentication settings, and individually configure VLAN
settings for each port from this page.
1 Go to Configuration > Ethernet Ports.
Figure 42. The Configuration > Ethernet Ports page
2 Review the following table and make changes as needed for each of the ports
labeled PORT 1 through PORT 4 (depending on AP model), which correspond
to the AP’s Ethernet ports.
Table 30. Individual Ethernet port options
Setting Description
Enable All Ethernet ports are enabled by default. Unchecking this box
next to a port disables that port entirely. If you do not want to
provide wired access through the AP, uncheck (clear) the
Enable box next to each LAN port.
Port Type See
Setting Ethernet Port Type for more detailed information.
•
Trunk Port: This port passes all VLAN traffic.
•
Access Port: This port provides network access.
• General Port: User-defined VLAN membership.
To Next Page
