Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 72
3
Configuring the Access Point
NOTE If the AP has been configured with SCG, vSCG, SZ or ZD controller-
compatible firmware, then the AP controller-compatible firmware is already installed
and configured; you have completed the AP installation. When you plan to manage
your Ruckus Wireless network using SCG, vSCG, SZ or ZD, refer to the associated
SCG, vSCG, SZ or ZD user documents, available from the Ruckus Wireless website
at
http://support.ruckuswireless.com/documents.
If the AP is to be run in a standalone configuration or is to be managed by a
FlexMaster manager, then continue with this section.
This chapter provides instructions for configuring Ruckus Wireless APs in a stand-
alone configuration or when the AP is to be managed by a FlexMaster manager. In
this chapter:
• Configuring Device Settings
• Configuring Internet Settings
• Configuring Local Subnets
• Configuring Wireless Settings
• Configuring Ethernet Ports
• Configuring Hotspot Service
To Next Page
Loading...
