Upgrading the Firmware
Upgrading Manually via the Web
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 136
CAUTION! Do not change any of the Image Control File, Username or Password
entries.
3 Click Perform Upgrade. A status bar appears during the upgrade process.
4 After the upgrade is completed, you must manually reboot the AP.
Upgrading Manually via the Web
1 In the Upgrade Method options, click Web.
2 If instructed to choose a different URL than the default value, type the URL of
the download Web site in Url. Remember to start the URL with
http://.
3 Click Perform Upgrade. A status bar appears during the upgrade process.
4 After the upgrade is completed, you must manually reboot the AP.
Upgrading Manually via Local File
If you have already saved an image file on your local computer, you can upgrade
directly using the Web interface.
1 In the Upgrade Method, select Local.
2 Click Choose File and locate the file on your local computer.
3 Select the file and click Open.
4 Click Perform Upgrade. Status messages appear during the upgrade and
reboot process.
Scheduling Automatic Upgrades
1 In the Upgrade Method options, click the button for your preferred choice.
2 Enter the appropriate information in the Host name or IP address field.
CAUTION! Do not change any of the Image Control File, Username or Password
entries.
3 Verify that the Auto Upgrade option is set to Enabled.
4 Tog g l e th e Interval to Check for Software Upgrade drop-down list to select your
preferred interval.
To Next Page
Loading...
