Installing the Access Point
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 12
Installing the Access Point
This User Guide assumes that the Ruckus Wireless outdoor APs have already been
installed and have already been initially configured as described in the corresponding
Mounting Guide, Installation Guide or Getting Started Guide.
NOTE DO NOT connect the AP to your live network when first connecting the AP
to an administrative computer. If you connect it to a live network with an active DHCP
server, then the AP can acquire a new IP address from DHCP and you will be unable
to access it via the default IP address (192.168.0.1).
If the AP has a new IP address, then reset the AP to the factory configuration as
described in the corresponding mounting or installation guide.
Because of different mounting and wiring procedures, each outdoor AP model has
its own installation guide. Refer to the installation guide that shipped with your
product for model-specific installation instructions. These documents are available
from
support.ruckuswireless.com
To Next Page
Loading...
