Resetting the AP to Factory Defaults
Scheduling Automatic Upgrades
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 139
Resetting the AP to Factory Defaults
WARNING! DO NOT reset the AP to factory defaults unless you are directed to do
so by Ruckus Wireless support staff or by a network administrator. Do this only if
you are able to immediately reconnect the restored AP to your computer, to
reconfigure it for Wi-Fi network use — as detailed in 2. Logging Into the Ruckus
Wireless AP Web Interface.
You can use the Web User interface to restore an inoperative AP to its factory default
settings, which completely erases the configuration currently active in the device.
Note that this disrupts all wireless network communications through this device.
1 Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page
appears.
2 Click Reset now (next to Reset the AP to factory settings).
3 When the confirmation warning appears, read the message and click OK if you
are certain that you want to restore the AP to factory defaults.
After a brief pause, you are automatically logged out of the AP. You must now
disconnect the AP from the switch (and the network) and reconnect it to your
computer, as described in the associated AP Installation Guide. At this time, you
can restore the network settings, then replace it in your site for full network use.
To Next Page
