Before You Begin: Preconfiguring the AP
Configuring the AP for Management by an SCG, vSCG, or SZ Controller
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 67
Configuring the AP for Management by an SCG, vSCG,
or SZ Controller
When your Ruckus Wireless network is managed by an SCG, vSCG or SZ controller,
you can manage APs using the controller rather than individually logging into each
AP’s Web interface.
If SCG, vSCG or SZ controllers are installed on the network, then follow the SCG,
vSCG or SZ instructions to configure the controller, and then connect the AP to
your network. The AP finds the SCG, vSCG or SZ, and then downloads the SCG-,
vSCG- or SZ-compatible AP firmware from the SCG, vSCG or SZ controller.
NOTE The AP must have some way of obtaining an IP address (IPv4 DHCP or IPv6
Auto Configuration).
Configuring the AP for Management by ZD
When your Ruckus Wireless network is managed by a ZD controller, you can
manage APs using the controller rather than individually logging into each AP’s Web
interface.
If ZoneDirector is installed on the network, then follow the instructions in the
ZoneDirector User Guide and connect the AP to your network. The AP finds the
ZD, and then downloads the ZD-compatible AP firmware from the ZD controller.
NOTE The AP must have some way of obtaining an IP address (IPv4 DHCP or IPv6
Auto Configuration).
To Next Page
Loading...
