Configuring Internet Settings
Obtaining and Assigning an IP Address
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 80
• (IPv6 only) IPv6 Secondary DNS Server: The IP address of the secondary
IPv6 DNS server.
• IPv4/IPv6 Address: Enter the static IP address that you want to assign
to the AP in either IPv4 (dot-decimal) or IPv6 (colon-separated) format.
• IPv4 Subnet Mask or IPv6 Prefix Length: Enter the subnet mask or prefix
length for the network.
• IPv4/IPv6 Gateway: Enter the gateway IP address of the Internet interface.
4 (IPv4 only) In IPv4 DNS Mode, select Auto or Manual.
• When you select Auto, the AP automatically searches for an IPv4 DNS server.
• When you select Manual, also make the following entries:
- IPv4 Primary DNS Server: The IP address of the primary DNS server.
- IPv4 Secondary DNS Server: The IP address of the secondary DNS
server.
5 Click Update Settings to save your changes.
PPPoE
Point to Point Protocol over Ethernet (PPPoE) is a Layer 2 protocol which uses the
PPP (Point to Point) protocol to connect a client system to a server system over a
one to one network link. All traffic for a PPPoE connected client must go through
the PPPoE server to reach the client. A PPPoE server can therefore be used to
route, NAT, firewall, and perform QoS traffic shaping.
If a PPPoE server is used to distribute Internet access to subscribers, the AP can
be configured with a PPPoE username and password to authenticate with the
PPPoE server.
PPPoE is available only for the IPv4 connection type; PPPoE is not supported in
IPv6 environments.
1 Go to Configuration > Internet.
2 Under IPv4 Connection Type, select PPPoE.
3 Enter a PPPoE Username.
4 Enter a PPPoE Password.
5 Retype the password in PPPoE Password Confirmation.
6 Click Update Settings to save your changes.
To Next Page
Loading...
