Configuring Local Subnets
Configuring L2TP Connection Settings
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 84
4 In Subnet Mask, typically you would want to leave the setting at its default value
(255.255.255.0) for a Class C subnet with an address pool of up to 254
addresses. An error appears if you enter an invalid IP/netmask combination.
5 In DHCP Server, click Enabled if you want to enable DHCP for this subnet.
Starting Address and Maximum DHCP Users fields appear.
6 In Starting Address, enter an address in the same subnet as the Local IP Address
(for example,
192.168.40.2).
7 In Maximum DHCP Users, enter the maximum number of clients that can be
assigned addresses by DHCP in this subnet (valid values are 1-253 if the default
subnet mask is used).
8 In Access VLAN, enter a VLAN ID to segment client traffic arriving from this subnet
from other network traffic. (Example: If you use the default 192.168.40.1
address range, you would generally use “40” as the VLAN for this subnet.)
9 Click Update Settings to save your changes. The local subnet is created
immediately and can now be applied to WLANs or Ethernet ports from their
respective configuration pages.
To Next Page
Loading...
