Sagem RT3000 - Page 66

For experienced Users: AT commands
SAGEM RT3000 65
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Command Function (factory setting in bold print)
APN APN = Access Point Name
AT+CPIN=PIN
Enter the PIN number of the SIM card
AT+CCLK=time
Set real time clock.
time = string type value; format is "yy/MM/dd,hh:mm:ss", where
characters indicate year (two last digits), month, day,
hour, minutes, seconds
AT+CCLK?
Displays the time: +CCLK: time (see above)
AT+CGMI Request manufacturer identification
AT+CGMM Request model identification
AT+CGMR Request revision identification
AT+CPWD=oldpw,
newpw
Change Password.
oldpw shall be the same old password specified for the facility
newpw is the new password;
maximum length of password can be determined with pwlength
AT+CPWD=
pwlength
Sets integer type maximum length of the password for the facility
AT+CREG=n
Network registration
Parameters:
n = 0: disable network registration unsolicited result code
1: enable network registration unsolicited result code
+CREG: <stat>
2: enable network registration and location information
unsolicited result code +CREG: <stat>[,<lac>,<ci>]
<stat>:
0: not registered, ME is not currently searching a new
operator to register to
1: registered, home network
2: not registered, but ME is currently searching a new
operator to register to
3: registration denied
4: unknown
5: registered
<lac>:
string type; two byte location area code in hexadecimal
format (e.g. "00C3" equals 195 in decimal)
<ci>: string type; two byte cell ID in hexadecimal format
AT+CCFC=reas,
mode
[,number
[,type
[,class
[,subaddr
[,satype
Call forwarding number and conditions control
reas =
0: unconditional
1: mobile busy
2: no reply
3: not reachable
4: all call forwardin
g