For experienced Users: AT commands
66 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Command Function (factory setting in bold print)
[,satype
[,time
[,status ]]]]]]]
5: all conditional call forwarding
mode =
0 disable
1 enable
2 query status
3 registration
4 erasure
number =
string type phone number of forwarding address in
format specified by type
type =
type of address octet in integer format
class =
is a sum of integers each representing a class of
information (default 1)
1: voice
2: data
4: fax
subaddr
string type subaddress of format specified by satype
satype
type of subaddress octet in integer format
time
1...30 when "no reply" is enabled or qurred, this gives
the time in seconds to wait before call is forwarded
(default value is 20)
status
0: not active
1: active
AT+CSQ Displays the Signal Quality
Parameters:
rssi =
0 -113 dbm or less
1 -111 dbm
2...30 -109... -53 dbm
31 -51 dbm or greater
99 not known or not detectable
ber = (in percent)
0...7 as RXQUAL values in the table in GSM 05.08 [20]
subclause 8.2.4
99 not known or not detectable
AT+CNUM Displays Subscriber Number
AT+CIMI Request international mobile subscriber identity
To Next Page
Loading...
