Sagem RT3000 - Page 68

For experienced Users: AT commands
SAGEM RT3000 67
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Command Function (factory setting in bold print)
AT+CGSN Request product serial number identification
AT+CGQREQ=[cid
[,precedence
[,delay
[,reliability
[,peak
[,mean ]]]]]]
This command specifies a Quality of Service Profile that is used
when the device sends an Activate PDP Context Request
message to the network.
If a value is omitted for a particular class then the value is
considered to be unspecified.
cid =
a numeric parameter which specifies a particular PDP
context definition (see the +CGDCONT and
+CGDSCONT commands)
precedence =
a numeric parameter which specifies the precedence
class
delay =
a numeric parameter which specifies the delay class
reliability =
a numeric parameter which specifies the reliability class
peak =
a numeric parameter which specifies the peak
throughput class
mean =
a numeric parameter which specifies the mean
throughput class
AT+CGQMIN=
[cid
[,precedence
[,delay
[,reliability
[,peak
[,mean ]]]]]]
Quality of Service Profile (Minimum acceptable)
cid = a numeric parameter which specifies a particular PDP
context definition (see the +CGDCONT and +CGDSCONT
commands)
precedence = numeric parameter for the precedence class
0: network subscribed value
1: High Priority Service commitments shall be maintained
ahead of precedence classes 2 and 3
2: Normal priority Service commitments shall be maintained
ahead of precedence class 3
3: Low priority
delay = numeric parameter for the delay class
reliability = numeric parameter for the reliability class
0: network subscribed value
1: Non real-time traffic, error-sensitive a
pp
lication that cannot