Sam4s SPS-300 Series - Single Item

Sam4s SPS-300 OP Manual v1.35 Service Mode Programming • 139
Use the PC Utility to Convert the Image
1. Install the SPS-300 PC Utility on your PC.
2. At your PC, start the SPS300 PC Utility. (Select Start, Programs, SHC PC
UTILITY, SPS300 PC UTILITY.) The Store Setting dialog box displays.
3. If you are starting the SPS300 PC Utility for the first time, you must define a store
name, or if a store is already defined, you can select the store from the drop-down
list. After the store is defined or selected, click Close. The PC Utility program
starts.
4. Move the bitmap (.bmp) logos you wish to use into the store directory
(i.e. C:\SPS-300PC\storename.)
5. At the PC Utility, choose Convert Logo Image from the Utility menu. The Bmp
dialog box displays.
6. Click FILE OPEN. Select the bitmap image you wish to use from the Open
dialog and click the Open command button.
7. Click the SAVE AS PRE IMG or SAVE AS POST IMG button.
8. When the image is selected, click OK. Verify that the message “Save As
UserPre.Img” or “Save As UserPost.Img” displays. If the file is too large, and
cannot be loaded, the message “File Size Error” displays.
Copy the Images to an SD Card
The PC Utility will create two image files:
• USERPRE.IMG
• USERPOST.IMG
They will be located on your PC at:
C:\SPS-300PC\Store Name
Copy the mages to the following path on your SD card:
SD\\SPS300\PgmBack\Store Name
Important: In the path: C:\SPS-300PC\Store Name, the store name is the name you have
defined as the store in the PC Utility. Note: You must use the same store name in the SPS-
300 Series ECR at System Options page 18. Note that the default store name is
“STORE_A”.