140 • Service Mode Programming Sam4s SPS-300 OP Manual v1.35
Load the Images by SD Card
1. Insert the SD card in the register’s SD slot.
2. Turn the control lock to the S position.
3. From the second page of the Service Mode menu, select “9 SD Card Operation”.
4. From the SD Card Operation menu select “4 PRE_IMAGE LOGO LOAD”.
5. The message “PREAMBLE LOGO LOADED!” will print on the receipt printer.
Saving Images from an SPS-300 to an SD Card
1. Insert the SD card in the register’s SD slot.
2. Turn the control lock to the S position.
3. From the second page of the Service Mode menu, select “9 SD Card Operation”.
4. From the SD Card Operation menu select “5 PRE_IMAGE LOGO BACKUP”.
5. The message “PREAMBLE LOGO BACKUP!” will print on the receipt printer.
To Next Page
Loading...
