Sam4s SPS-300 OP Manual v1.35 Program Mode Programming • 247
DataTran Message
When a DataTran integrated payment appliance is connected, you can print a custom message
with up to four lines on the electronic payment draft receipt.
From the LOGO DESC. PROGRAM screen, press 6 to display the DATATRAN
MESSAGE screen:
DATATRAN MESSAGE ↓
LINE 1 :
LINE 2 :
LINE 3 :
Using the alpha numeric keyboard overlay (SPS-320/SPS-340, type the descriptor.
For the SPS-345 use the descriptor code method (see page 147.) Each line can
contain up to 32 characters. If you make a mistake, press the BACKSPACE key (on
the alpha overlay or enter the backspace code 97 if you are using the descriptor code
method) to erase the previous character. After you have completed typing the first
line, press CASH to accept the new message and advance to the next line, or press
CLEAR to return to the LOGO DESC. PROGRAM screen without making any
changes.
Press CASH repeatedly, or press PAGE UP and/or PAGE DOWN to locate the next
line of the message you wish to program. After the last line on the first page, the
screen shifts to display line #4 of the message. Using the same procedure, continue
programming each line as necessary. Press CLEAR at any time to exit and return to
the LOGO DESC. PROGRAM screen.
To Next Page
Loading...
