158 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
Group Programming
Up to 99 groups (the exact number is determined by memory allocation) are available to
summarize PLU sales. Group totals appear on reports, so that you can track sales of different
types of items.
• The group descriptors programmed here will replace the default descriptors GROUP 1
through GROUP 99 that appear on reports.
• Each PLU can report totals to one, two or three different groups. If a PLU sends totals
to more than one group, the group total that appears on the Group report will not
represent PLU sales. Therefore, you also have the option of deciding whether each
group's total will add to the group total on the Group report.
To Program Groups
At the PGM control lock position menu, press 1 for GROUP. The GROUP
PROGRAMMING screen displays: (The maximum group number is set by memory
allocation.)
GROUP PROGRAMMING
GROUP NO? (1-20) 0
Enter the number of the group to be programmed, press CASH. The GROUP#
PROGRAMMING screen displays:
GROUP #1 PROGRAMMING
DESC : GROUP 1
ADD TO GROUP TTL Y
SEND TO KP N
KP PORT# : 1 2 3 4 R
SAT. N N N N Y
SER. N N N N
PRINT RED ON KP N
Press PAGE DOWN to view the second page of group programming:
To Next Page
Loading...
