Sam4s SPS-300 Series - Manual Card Entry

Sam4s SPS-300 OP Manual v1.35 Program Mode Programming • 259
Editing an Existing Macro
After selecting a macro to edit, the screen displays the keystrokes currently
programmed.
1. ONE 
2. TWO
3. THREE
4. FOUR
5.
6.
7.
8.
Press the YES/NO key to advance the cursor to the line you wish to edit.
With the cursor pointing at a line, press (or select) the new function you wish to place
in the macro sequence.
If you wish to remove a key stroke from a macro, replace the current function with
the INACTIVE function by pressing the PAGE DOWN to display a key code list,
then enter 4 4 5: press CASH.