141
Member of Exel group
DRT582165110
A - 2023/03
• Step 9:
If everything goes well, the bus starts (see Bus
status) and it will be possible to produce.
6.4.1.4. .Replace a card
• Step 1:
Wait for the end of the scan.
If a card is defective, it can be replaced without
reconfiguring the bus. At the next power up, the
configuration will be updated automatically.
However, if more than one card is replaced or if the
order of the cards is changed, it will be necessary to
reconfigure the bus.
To Next Page
Loading...