SAMES KREMLIN Cyclomix Evo - Page 159

DEC EU 578156130
1
Sames
Siège Social / Headquarter: 13, chemin de Malacher - CS70086 - 38243 Meylan Cedex - France - Tél / Phone: +33 (0)4 76 41 60 60
SAS au capital de 12.720.000 euros | RCS Grenoble: 572 051 688 | Code APE: 2829B | TVA intracom: FR36 572051688
DECLARATION OF INCORPORATION
OF PARTLY COMPLETED MACHINERY
EU DECLARATION OF CONFORMITY
(1) The manufacturer declares herewith declares that the equipment is in conformity with the relevant Union harmonization legislation.
(2) Equipment type
Electronic Dosing System Cyclomix® Evo
(3) Applicable Directives
2006/42/CE
(4) The relevant technical documentation was compiled
as specified in annex VII, part B .
The essential health and safety requirements mentioned in the Directive 2006/42/CE on
Machinery have been applied.
Articles: 1.1.5 ,1.1.6, 1.3.1, 1.3.2, 1.3.4, 1.5.1, 1.5.2
(5) That partly completed machinery is also in conformity with the provisions of
2014/34/UE
(6)
Marking
Electronic Dosing System
II 2G Ex h IIB T4 Gb X => dosing system in ATEX Zone
II (2)G Ex[ia Gb] IIB => piloting box outside of ATEX zone
Equipment
Approval N°
Zener barrier
BAS 01 ATEX 7005
Electrovalve ATEX
LCIE 12 ATEX 3005 X
Sensor element ATEX
BVS 08 ATEX E 101
Mass Flowmeter
BVS 17 ATEX E 074
Cylinder
21 ATEX 0036
Pressure sensor
SEV 11 ATEX 0129
Fiber optic amplifier sensor
BVS 17 ATEX E 041
Each individual electrical component used in zone 1 is in
conformity with the 2014/34/UE directive. Their combined
presence in the assembly hasnothighlighted any additional risks
that would necessitate a comprehensive assesment of this type
of machinery.
(7) Harmonised
standards
EN ISO 80079-36 : 2016
EN ISO 80079-37 : 2016
EN 1127-1 : 2019
(8) Conformity
assessment
procedure
Module A Technical documentation (Annex VIII)
2014/30/UE
Electromagnetic Compatibility Directive
2014/35/UE
Low Voltage Directive
2012/19/UE
Waste Electrical and Electronic Equipment (WEEE)
(9) Notified body
INERIS 0080 – 60550 Verneuil-en-Halatte – France – INERIS-EQEN
/ n° INERIS-CERN 038002/ 22.
(10) This partly completed machinery must not be put into service until the final machinery in which it is to be
incorporated has been declared in conformity with Directive 2006/42/CE on Machinery.
Sames is allowed to compil the technical documentation.
Sames undertakes to transmit, in response to a reasoned request by the national authorities, relevant information
on the partly completed machinery in the most appropriate form. This declaration of incorporation
of
partly completed machinery and this declaration of conformity are issued under the sole responsibility of the
manufacturer.
Director of the STAINS site - Executive Management (EM)
Hervé WALTER
Established in Stains, on
DocuSign Envelope ID: CAABFD13-50FF-4086-B5E0-EC6357CBAD11
25-nov.-22 | 08:19 CET