41
Member of Exel group
DRT582165110
A - 2023/03
# LED status Description
1 red LED
When ON it signals that the program is running.
It blinks when 3 times slowly during the board boot.
It blinks fast during the board identification (cf. Identify in Maintenance on CCB).
2 LED RUN (green)
This LED indicates the state of the EtherCAT chip. When ON it signals that the chip
is operational to run.
2 LED RDY (orange)
When ON (whether it blinks or flashes or is on), it signals that the EtherCAT chip is
not running.
• ÒUser should check that both switches (cf. 2) are set to OFF and reboot the
cabinet.
3 red LED It shows that the board is powered.
4 LED COM 0 (green/red)
This LED indicates the status of the EtherCAT network. Extract from the documen-
tation ETGETG.1300 S (R) V1.1.
When it is green (see below)
When red: it is that a critical communication or application error has occurred.
Indicator states Slave state Description
Off Initialization The device is in the INIT state.
Blinking Pre-operational
The device is in
pre-operational state
Single flash
Safe
operational
The device is in state SAFE-
OPERATIONAL.
ON Opérational
The device is in state
OPERATIONAL.
Flikering
Initialization or
bootstrap.
The device is booting and has
not yet entered the entered
the INIT state.
To Next Page
Loading...