47
Member of Exel group
DRT582165110
A - 2023/03
Control box block
The last block is for information about the control box.
• The first character identifies the type of communication present in the box and allowing to communicate with
another equipment.
• The second character indicates the number of flowmeters present in the box. These flowmeters, connected to
the gun's atomization air, allow the Cyclomix® Evo to know when it is open. This makes it possible to verify the
proper functioning of the Cyclomix® Evo and in particular to detect the presence of a leak or the malfunction
of a flow meter.
• The third character allows the user to define the type of enclosure and the possibility or not to install the
product board in an ATEX zone.
Codification of the product board
The significant designation of the product board is defined in exactly the same way as the complete Cyclomix® Evo
with 2 exceptions:
• The prefix #EVO becomes #EVOP
• The first 2 characters of the block ''command box'' take fixed values.
In fact, the first character will systematically take the value 9 and the second will be 0.
The last character of this block will be defined in the same way as for the complete Cyclomix® Evo and will notably
allow the type of solenoid valve to be defined for the control of the injection valve.
Example of a significant designation for the product board:
Codification of the Cyclomix
®
Evo control box
The significant designation of the control box is composed of 35 characters that allow the Cyclomix® Evo control box
to be defined, manufactured and configured in its entirety.
The significant designation of the box is divided into 7 groups, each defining a part of the box.
These 7 groups are preceded by a prefix: #EVOCTRL-.
The first group indicates which directive the enclosure is subject to.
This allows to know if the enclosure is equipped with intrinsic barriers or not.
The second group indicates the number of circuits powered by the Cyclomix® Evo.
The third group indicates the type of communication card present in the cabinet.
The fourth group indicates the number of Input/Output cards present in the cabinet.
This information allows you to know, among other things, how many different products can be used.
The fifth group indicates the number and position of the solenoid valve blocks present.
The sixth group indicates the type and position of the flowmeters that can be connected to the box.
• The seventh and last group indicates the number of debistats present in the box..
Example of configuration
Prefix
Technology Comp. A
0 Without communication 0 None 1 CE
1 Ethernet 1 1 air flow switch 2 ATEX
2 Profinet 2 2 air flow switches
3 Modbus
4 Reserved
5 cc-link
Prefix Technology
Comp.
A
Comp.
B
Comp.
C
Injection
and mixing
Product
regulator
Painting
circuits
Options
Coffret de
commande
#EVOP - 2PM - 04F131 - 02X163 - 00X000 - 3200H1X0 - XX - 30002 - 21000RC - 902
Prefix Directive
Number of
gun(s)
Type of communication
Number of I/
O cards
Distribution of the
solenoid valve
blocks
Type of
flowmeters
Number of
debistats
#EVOCTRL - EX - 2G - ET - 1 - 10110000 - GGX - 2F
To Next Page
Loading...