Sames PPH 607 - Page 11

Revised A 11 6301
Warranty - Responsibility
SAMES Technologies agrees to correct any malfunction resulting from a fault in the design, the material
or the fabrication within limitations listed below.
Any request that the warranty be applied must be made in writing and precisely state the claim.
SAMES Technologies never warranties any equipment which has not been operated, maintained and
cleaned according to their recommendations.
In addition, SAMES Technologies does not warranty their equipment if outfitted with spare parts not
approved by SAMES Technologies .
Specifically, the warranty does not cover damage resulting of:
• negligence or lack of supervision from the customer
• incorrect utilization
• improper procedure follow up
• use of non
SAMES Technologies approved control system
• accident and/or collision
• acts of God
• bad air filtration (solid particles > 5 micron diameter)
• bad paint / solvent
• use of o-rings not complying with SAMES Technologies specifications
• usage of turbine below minimum bearing air pressure (< 90 PSI (6 bars) at atomizer inlet and
90 psi at the pneumatic control panel)
• maximum speed exceeding 45,000 rpm limit
• usage with unbalanced components (dry paint on bellcup, clip, rotor or damaged bellcups),
• air circuits contaminated by fluids or other substances
The SAMES Technologies PPH 607 atomizer is covered by a 12-months warranty (two eight hours
working shift).
In addition, the warranty covers 10,000 hours of operation for the PPH 607 bearing air turbine.
The warranty does not apply to wearing parts such as bellcups, removable regulator components, clips,
and o-rings.
The warranty starts from the date the customer provides Code : RT 6301 acceptance (buy off).
Under no circumstances within the frame of this warranty will SAMES Technologies be held responsible
for any bodily injury or loss of production.