Revised A 66 6301
7. Cleaning procedures (continued)
7.1. Procedure A
WARNING : Turbine must be OFF. Bearing air and shaping must remain under pressure in order
to stop solvent flow between the bellcup and the inner ring.
• Step 1: Clean the tightening ring, the aluminium cover and the outer bellcup surface with a clean
rag.
• Step 2: Make sure that the grooves of the aluminium cover are clean
• Step 3: Dry with compressed air
1 Bellcup
2 Aluminium cover
3 Aluminium cover groove
DES01515
1
2
3
To Next Page
Loading...