Santerno Sinus M - 11.1 Operating status monitoring; Power on display

11-3
 Power on display
Group Code Parameter Setting range Initial
Function
group 2
H72 [Power on display] 0
Frequency command (0.00)
0
1
Accel time (ACC)
2
Decel time (DEC)
3
Drive mode (drv)
4
Frequency mode (Frq)
5
Multi-step frequency 1 (St1)
6
Multi-step frequency 2 (St2)
7
Multi-step frequency 3 (St3)
8
Output current (CUr)
9
Motor rpm (rPM)
10
Inverter DC link voltage (dCL)
11
User display select (vOL)
12
Fault display 1(nOn)
13
Operating direction select (drC)
14
Output current 2
15
Motor rpm 2
16
Inverter DC link voltage 2
17
User display select 2
 Select the parameter to be displayed on the keypad after Power ON.

The output current and motor rpm are displayed when 8, 9, 14, 15 are set.