Santerno Sinus M - 9.4 Accel;Decel time and pattern setting; Accel;Decel Disable

9-16
 Note that setting Frequency Ref. for Accel/decel (H70) is set to Max Freq and target freq is set below
Max freq. the shape of S-curve may be distorted.
 Accel time for S-curve setting
2
18
2
17 H
ACC
H
ACCACC ×+×+=
 Decel time for S-curve setting
2
18
2
17 H
dEC
H
dECdEC ×+×+=
 ACC, dEC indicate the set time in Drive group.
 Accel/Decel Disable
Group Code Parameter Name Setting Range Initial Unit
I/O group I17
[Multi-function input terminal
P1 define]
-
0 ~29
0
~ ~
I24
[Multi-function input
terminal P8 define]
24
7

Select one terminal among Multi-function input terminals 1-8 to define Accel/Decel disable.
 If P8 is selected, set I24 to 24 to activate this function.
Freq.
P8
Operating
command
☞Note: If Target
Frequency is below Max
Frequency, the waveform
will be shown with the top
portion cut out.
Freq
H17
H17
H18
H18
Accel/decel
Ref Freq
Target Freq