Sartorius Arium Comfort I H2O-I Series - Initial Startup; System Startup; Setting the Language

Initial Startup
Operating Instructions Arium
®
Comfort I, Comfort II 23
6 Initial Startup
Once the Arium
®
Comfort and Arium
®
Bagtank have been set up and
connected, you can put your system into operation.
NOTICE
According to device specifications (Arium
®
Comfort and Arium
®
Bagtank),
this requires a supply voltage of 230 - 240 V, 50 Hz or 115 V, 60 Hz,
depending on the country standard. You may not connect the system to
the power supply if the connection conditions at the setup location do
not correspond to the information on the manufacturer’s ID labels for the
Arium
®
Comfort and Arium
®
Bagtank.
It takes between 210 and 330 minutes to set up the Arium
®
Comfort
(depending on the version of the device).
For initial startup, carry out steps 6.1 to 6.12. This operating manual will guide
you step-by-step through the sequence of the displays.
6.1 System Startup
All system settings (e.g. date, time, displayed values, etc.) configured during
initial startup can be subsequently changed in the system menu.
t Connect the power plug on the power supply of your Arium
®
Comfort
systems to the mains voltage. Next, switch on your Arium
®
Comfort
system via the power switch.
t The Arium
®
Comfort system will then perform a system check and display
the start screen shown on the left.
6.2 Setting the Language
t Select the language for the display. The factory setting is English.
Not all languages are visible on the display at the same time. Scroll with the
arrow keys to display all languages.
Startup > Set language
English
English
French
Italian

