Sartorius Arium Comfort I H2O-I Series - Pin; Resetting to Default; System Status; Device

System Menu
Operating Instructions Arium
®
Comfort I, Comfort II 51
8.3.15 Pin
This function lets you limit access to the Menu  Settings and the Care
modes. If you have active PIN protection, these two sections can only be
accessed by entering a PIN.
The PIN protection function is located under Menu  Settings  PIN. The
factory setting for PIN protection is deactivated and the standard PIN is set
to “0000”.
If you forget your PIN, it can only be reset by a service technician.
8.3.16 Resetting to Default
Under Menu  Settings  Reset to default, you can restore your
Arium
®

configured on the system after initial startup (e.g. Limit values, Display and
Acoustic signals, etc.).
The system reboots after connection.
8.4 System Status
Under Menu  System status, information about the following sub items
can be obtained:
 Device
 Measured Values
 Timer
 Service
 Warnings
 Errors
8.4.1 Device
Under Menu  System status  Device, you can display the following
information:
 Model
 Serial number
 Software version
 MAC address (from software version V05.00)
r r PIN
Status: Inactive
Change PIN
Back

r r Reset to default
Restore default settings

Cancel
Menu r System status
Device
Measured Values
Timer
Service


r r Device
Arium
®
Comfort II TOC
S/N: 09394001
Software V3.08
MAC: 1A:2B:3C:4D:5E:6F
Back