Care and Maintenance
Operating Instructions Arium
®
Comfort I, Comfort II 65
9.4 Replace RO Modules
The Arium
®
Comfort system is supplied with potable water. During ultrapure
water purification (tank water), the potable water is cleaned through RO
modules. Potable water contains salts, microorganisms and particles which
can lead to blockages in the RO modules. To remove these blockages, the
RO modules are cleaned regularly with the system cleaning function. This
extends the service life of the RO modules. Depending on the quality of the
potable water, blockages can occur that can no longer be removed by
system cleaning. To ensure consistently pure water quality, the RO modules
should be replaced every 12 – 24 months.
The replacement interval is directly dependent on the system cleaning
interval (2 – 4 months). The RO modules should be replaced after 6 expired
system cleaning intervals.
You can start the replace RO modules function under Care Replace RO
modules.
t Disconnect “Tank Outlet” tubing from the Arium
®
Bagtank (“IN” tank
connection) and attach it to the drain.
t Start the depressurization process.
y The water pressure in the Arium
®
Comfort system is reduced.
Depressurization takes a few seconds.
t Choose whether you want to likewise replace the prefilter and | or
prefilter and softener (Comfort II only).
Last chance to cancel
Care r RO Modules
Disconnect “Tank outlet”
tubing from tank and direct
towards drain
Cancel OK
Care r RO Modules
Start depressurization
Start
Care r RO Modules
Depressurization
Care r RO Modules
Will you also be replacing
the prefilter and softener?
No Yes
To Next Page
Loading...
