Sartorius Arium Comfort I H2O-I Series - Setting the Date and Time; Setting the Measurement Unit; Ijust

Initial Startup
24 Operating Instructions Arium
®
Comfort I, Comfort II
6.3 Setting the Date and Time
t Use this option to select the desired date and time format.
t Set date and time.
6.4 Setting the Measurement Unit
t You can set the unit in which your measured values should be indicated
on the display.
It is also possible to display the measured value without compensated
display. After startup, the displayed values can be changed in the open
menu item: Settings r Displayed values (see Chapter "8.3.1 Displayed
Values", page 43).
6.5 iJust
For optimal operation of the system, Sartorius recommends using the iJust
function. Use this function to enter values for CO
2
and water hardness of
the feed water. If you do not want to use iJust, cancel the procedure. It is
always possible to activate iJust in the System menu at a later time. Refer
to Chapter "8.3.3 iJust", page 44 for further information on the iJust
function.
Set date/time
DD.MM.YY 24 h
MM/DD/YY AM/PM


Set date/time
DD.MM.YY 24 h
10.04.12 11:43
 

Setting the Measurement Unit
µS/cm comp.
MΩcm comp.


iJust
Water hardness and CO2
Enter content in mg/l.
Cancel to not use iJust.
Cancel OK