Sartorius Arium Comfort I H2O-I Series - Volume-Controlled Dispensing

Operation
36 Operating Instructions Arium
®
Comfort I, Comfort II
7.2.2 Volume-Controlled Dispensing
To perform volume-controlled dispensing, place an appropriately large
vessel under the water outlet and in the operating mode press the (R)
“ ” key.
y The currently set dispensing volume is shown in the display. For setting
the dispensing volume, switch to volume entry.
t Set the desired dispensing volume.
The following dispensing volumes can be adjusted according to the given
scale intervals. The changed dispensing volume (0.1 L in the example) is
indicated in the display.
Dispensing volume Scale interval
0.1 L – 2.0 L 0.1 L
2 L – 20 L 1 L
20 L – 60 L 5 L
The adjustable dispensing volume depends on the connected Arium
®
Bagtank.
t Switch to “Volume-controlled” and start volume-controlled dispensing.
y The remaining dispensing volume is indicated in the display.
t The remaining dispensing volume is indicated in the display (R) “
Stop
”.
The system then switches back to the operating mode.
The termination of volume-controlled dispensing is signaled acoustically via
the confirmation beep (see Chapter "8.3.13 Acoustic Signals", page 50).
Dispense
Favorite mode
Set favorites

Volume-controlled
0.20 l
 

Dispense
Set dispensing volume
0.1 l
 

Dispense
Volume-controlled
0.1 l
Time-controlled
5.0 min
 Start
11:43 10.04.15
0.055 µS/cm c
1.0 ppb TOC
0.1 l
Stop