Sartorius Arium Comfort I H2O-I Series - Replace Softener (on Comfort II Version Only)

Care and Maintenance
68 Operating Instructions Arium
®
Comfort I, Comfort II
9.5 Replace Softener (on Comfort II version only)
Under Care  Replace softener you can replace the softener.
t Disconnect “Tank Outlet” tubing from the Arium
®
Bagtank (“IN” tank
connection) and attach it to the drain.
t Start the depressurization process.
y The water pressure in the system is reduced. Depressurization takes a
few seconds.
t Choose whether you want to likewise replace the prefilter.
t Follow the corresponding instructions on the display. If you likewise want
to replace the prefilter, carry out replacement in this step. The procedure
for replacing the prefilter is described in Chapter "9.3 Replace Prefilter",
page 62.
t Carry out the following steps to replace the softener. How to replace the
softener is additionally described in the installation instructions accom-
panying the softener.
Care r Softener
Disconnect “Tank outlet”
tubing from tank and direct
towards drain
Cancel OK
Last chance to cancel
Care r Softener
Start depressurization
Start
Care r RO Module
Depressurization
Care r Softener
Will you also be replacing the
prefilter?
No Yes
Care r Softener
Replace the prefilter and
softener according to the
operating instructions
Back OK