System Menu
Operating Instructions Arium
®
Comfort I, Comfort II 43
8.3.1 Displayed Values
Under Menu Settings Displayed values, you can set the unit in which
the conductivity and | or the temperature will be indicated in the display.
Conductivity
In the conductivity menu, select the desired unit of measure.
The following units are available:
µS/cm comp.
µS/cm
Compensated displays are compensated to a reference temperature of
25°C. In the operating mode, a “c” attached to the unit of measure indicates
a compensated display.
If no valid conductivity value exists, the unit of measure will flash. This can
take place, for example, after exiting the ECO mode. The flashing display
indicates that a conductivity measurement is being performed. The
measurement takes a minute at the most.
In the vernacular of the Arium
®
Comfort system, the term “conductivity”
Temperature
In the Temperature menu, you can select between the units °C and °F.
r r Displayed values
Conductivity
Temperature
Back
r r r Temperature
°C
°F
Show always
To Next Page
Loading...
