Sartorius Arium Comfort I H2O-I Series - Conclude Startup

Initial Startup
32 Operating Instructions Arium
®
Comfort I, Comfort II
6.10 Conclude startup
t Connect the power supply on the Arium
®
Bagtank to the mains supply.
Then, turn the Arium
®
Bagtank on via the power switch (right side on the
bottom).
Only one Arium
®
Bagtank 50 or 100, each with built-in pump, is equipped
with a power supply. If you are using an Arium
®
Bagtank without power
supply, skip the above item by confirming with “OK”.
t Attach the sampling tubing to the dispenser unit (cf. Fig. on page 8).
t Direct sampling tubing towards drain.
t Start System cleaning.
y The Arium
®
Comfort system and the connected Arium
®
Bagtank are
rinsed for 15 minutes. The remaining rinsing time is shown on the display.
If you are operating an Arium
®
Comfort system with connected TOC
monitor, the rinsing time is 10 minutes longer.
Startup
Connect the Bagtank power
cord to the power supply
OK
Startup
Attach the sampling tubing to
the dispenser unit
OK
Startup
Direct sampling tubing
towards drain
OK
Startup
Press Start to rinse
the system
Start
Startup
Rinsing
15 min
Cancel