Safety Information
Operating Instructions
®
Comfort I, Comfort II 7
NOTICE
Danger of irreversible damage to Arium
®
Comfort system components!
Be sure to replace defective fuses with those of the same type and
rating.
Make sure that the outlet tubing for the rinse water is directed to an
open drain.
Protect against frost.
When installing a new UV lamp in your Arium
®
Comfort, do not touch the
bulb with your bare hands. Fingerprints can cause damage to the bulb.
Never connect peripheral devices to the device interfaces unless they
have been recommended by Sartorius. This will prevent damage to your
Arium
®
Comfort system.
Never unplug any cables from your Arium
®
Comfort when it is running as
this can cause malfunctions.
2.1 Intended Use
The Arium
®
Comfort system was designed for the sole purpose of creating
pure and ultrapure water for laboratory use. In order to ensure proper device
operation, you should only use the filer media and | or accessories listed in
this manual. Using the device for purposes other than that listed here is
considered improper use.
The Arium
®
Comfort system may only be operated by trained personnel.
Only operate your Arium
®
Comfort system with original accessories or
replacement parts. If you modify this water purification device inde-
pendently, the performance and operating safety of the system are no
longer guaranteed. This can also endanger the safety of the operator.
If you encounter any problems with your system, please contact your
local Sartorius Service Center.
Please take all pertinent precautions to prevent accidents and observe
the generally valid technical and occupational safety rules and
regulations.
Only use materials recommended by Sartorius (e.g. connections, seals,
tools, spare parts, cleaning agents, pre-treatment cartridges, softeners
and RO modules).
To Next Page
Loading...
