Initial Startup
Operating Instructions Arium
®
Comfort I, Comfort II 31
y The Arium
®
Comfort system is rinsed. The remaining rinsing time is
shown on the display.
The timers for the RO modules, prefilter, softener (Comfort II version only)
and cleaning (system cleaning and bag replacement) are reset after rinsing.
6.9 Start Tank Filling
t Connect the “Tank Outlet” connector of your Arium
®
system (ultrapure
water outlet) to the “IN” connection on the Arium
®
Bagtank. Use the
“Tank Outlet” pre-assembled tubing from “Tank Kit 1” of the Arium
®
Bagtank for this purpose.
t Connect the “Tank Inlet” of your Arium
®
system (ultrapure water inlet) to
the “OUT” connection on the Arium
®
Bagtank. Use the “Tank Inlet”
pre-assembled tubing from the accessory kit of your Arium
®
Comfort
system.
t Start tank filling.
y The current fill level shown on the display. Tank filling can take 2 to
progress bar is full.
During tank filling, the Bagtank 20 is completely filled, and the Bagtank 50
and Bagtank 100 are filled with approx. 30 L. The initial startup process is
then resumed.
Startup
Rinsing
50.0 min
Cancel
Startup
Connect “Tank Outlet” tubing
to tank
OK
Startup
Connect tubing “Tank Inlet”
to the tank
OK
Startup
Start tank filling
Start
Startup
Tank filling
IIIIIIIII--------
Cancel Info
To Next Page
Loading...
