Sartorius Combics 3 Series User Manual

100
Application Initialization Data
Which data is included in this block depends on the active application. In the “Counting"
application, for example, the reference sample quantity and reference weight are printed
(plus a blank line).
"Counting" print block example:
nRef 10 pcs
wRef + 0.035 kg
Scale Identification
Print image example for weighing platform serial number:
Ser.no. 1234567890
Scale Identification
This content is application-dependent. If provided in the application, the gross, net and
tare weights are usually printed, followed by a blank line. This block is terminated by a
dotted line. “Counting" application print image example:
G# + 1.402 kg
T + 0.200 kg
N + 1.202 kg
Qnt 34 pcs
--------------------
GMP-compliant printouts
When this function, the printout is supplemented with a GMP header and a GMP footer
(GMP: “Good Manufacturing Practice”).
If the GMP-compliant printout is activated, the A symbol remains displayed until the
GMP footer is printed.
Setting: Setup menu under “
Device parameters:Config.
printout:ISO/GLP/GMP- printout."
You can choose from the following settings:
– GMP-compliant printout off (factory setting)
– GMP-compliant printout for multiple application results
The GMP header is included from the first printout generated subsequent to the
activation of the GMP printout.
The GMP footer is printed after several measurement results by pressing and holding
the p key, e.g. for component printing (menu item “For multiple application results").
In this case, the
T symbol remains visible until the GMP footer is printed.
If you toggle to a different platform while a GMP printout of several measured results
is being generated, the GMP footer for the platform used up to that point is generated
when you press the n key. The GMP header for the other platform is included on the
next printout generated.
A GMP-compliant printout is generated automatically at the conclusion of calibration/
adjustment and linearization routines, as well as when you set or delete a preload.
If you use a label printer for GMP-compliant printouts, you may find that a single label is
not long enough for the data printed. If this is the case, you can activate the automatic
form feed after each printout of a GMP header and measurement results. The following
provides sample GMP headers and footers (see “Sample Printouts").
Data Interfaces

Sartorius Combics 3 Series Specifications

General

Brand	Sartorius
Model	Combics 3 Series
Category	Accessories
Language	English