Sartorius Combics 3 Series User Manual

Overview of the Setup Menu in Service Mode
o = Factory setting
x = User-defined setting
Service password entry Setup Application parameters, please refer to the “Basic Application Programs” manual
Fn key “Setup Overview (Parameters)"
Device parameters
Info, see the “Setup Overview (Parameters)" section
Language, see the “Setup Overview (Parameters)" section
Setup access with service password
Device parameters
WP1
RS-232
1
)
SBI standard
SBI verifiable
o IS-232
ADC-232
RS-485
1
)
o IS-485
ADC-485
Internal
ADC configuration (see the “Setup Menu for ADC Configuration" section)
Calibration/Adjustment
CAL key function
o Ext. cal./adj.; factory-def. wt.
Ext. cal./adjust.; user-defined weight
Ext. lineariz.; factory-def. wts
Ext. lineariz.; user-def. wts
Set preload
Delete preload
Key blocked
Cal./adj. sequence
Cal. then auto adjust
o Cal. then manual adjust
isoCAL function
3
)
o Off
Adjustment prompt
Activate external adjustment
2
)
o Activated
Deactivated
Parameter for external weight
Cal./adj. weight:
Lin. weight 1...4:
Adjust without weights
2
)
Input parameters
Nominal load:
Resolution:
Sensitivity 1…4:
Save parameters
Yes
o No
Geographical data
2
)
Input parameters
Geographical latitude
Altitude
Gravitational
acceleration
Save parameters
Yes
o No
1
) Equipment version: – then blocked internally
2
) = Not available on devices verified for use in legal metrology
3
) only when operated with Sartorius IS weighing platforms or an external ADC
18
Configuring Weighing Platforms

Sartorius Combics 3 Series Specifications

General

Brand	Sartorius
Model	Combics 3 Series
Category	Accessories
Language	English