Sartorius Combics 3 Series - Setup Overview (Parameters)

Operating Design
Setup Overview (Parameters)
o = Factory settings
W = User-defined setting
Setup
Application parameters: Please refer to the “Basic Application Programs” manual
Fn key function
o Off
Unit conversion
SQMIN (only possible when the display has been turned on in the “Device parameters:SQMin" menu item)
Device parameters
WP 1
RS-232
1
)
SBI standard
SBI verifiable
o IS-232
ADC-232
RS-485
1
)
o IS-485
ADC-485
Internal
Calibration/Adjustment
CAL key function
o Ext. cal./adj.; factory-def. wt.
Ext. cal./adj.; user-defined wt.
Key blocked
Cal./adj. sequence
Cal. then auto adjust
o Cal. then manual adjust
isoCAL function
3
)
o Off
Adjustment prompt
Activate external adjustment
2
)
o Activated
Deactivated
Parameter for external weight
Cal./adj. weight:
Calibration/adjustment unit
Grams /g
Kilograms /kg
Tons /t
Pounds /lb
Adapt filter
Min. vibration
o Normal vibration
Strong vibration
Extreme vibration
Application filter
o Final readout
Filling mode
Low filtering
Without filtering
Stability range
1/4 digit
1/2 digit
1 digit
2
)
o 2 digits
2
)
4 digits
2
)
8 digits
2
)
1
) Equipment version: – then blocked internally
2
) Not available on devices verified for use in legal metrology
3
) Only when operated with Sartorius IS weighing platforms or an external ADC
56